AverageCakeSlice

@AverageCakeSlice@sh.itjust.works

This profile is from a federated server and may be incomplete. Browse more on the original instance.

AverageCakeSlice,

If you happen to have a 3D printer, Gridfinity would be my go-to solution. Otherwise, those Kinetic Labs containers seem like your best bet.

AverageCakeSlice,

Use a 0.6mm nozzle, it’ll change your life.

AverageCakeSlice,

I’ve got a 0.8, I just haven’t tried it yet. I feel like the prints would be too imprecise for most applications though, no?

How screwed am I? (i.imgur.com)

First keyboard build; everything was going reasonably fine until I had assembled the whole thing and noticed the backspace key was not sitting right. See picture for culprit. (Not pictured: the idiot who didn’t set the stabilizer correctly) Can I reseat the stabilizer without (further) tearing this thing down to the studs?...

AverageCakeSlice,

Oh man, I’ve had to desolder a whole board before after forgetting the stabs. Turned a one hour project into a three hour project.

  • All
  • Subscribed
  • Moderated
  • Favorites
  • •
  • fightinggames
  • All magazines
    •