Threads

The 2x OLED displays are still a work in progress

Hi all,...

Hi all,...

I created a 2d surface that I can perform a linear extrusion on, however the result it obviously a hard edge on the extrusion. I would love to be able to add a bezel - either rounded or at 45 degrees. Is there an easy way?

I’ve got the basics down, but now looking to do something more complex, and unsure if it’s possible. I have imported a flat shape (a pcb), and I can extrude this out. What I want to do however is to rotate it on its axis, and then extrude it down the z-axis (not directly out from the surface). Is this possible, and if so,...

Is there such a thing as an online pcb tester? As in ‘here is my pcb design, when I connect this, I expect it to register as a circuit on these two pins’

Hey there,...

Hi all,...

I’ve never been much of a musical person. But my kid was playing with a toy piano the other day, pressing buttons and whatnot. I lay my fingers on the keyboard and thought “hmmm… kinda like the home row”....

A couple of keycaps short, but I’ll move them across from my daily driver (at the top) when the time is right. All soldering is done. I just need to program the firmware. But it’s likely not going to happen until the weekend after next due to other commitments. Can’t wait to try it out though!...

Only changes have been to remove the outer most column and so move from 40 keys to 36, plus a change of keycaps and some angled risers for the keycaps on both top and bottom rows.

It’s going to be a 24 key, choc keyboard with a 2” TFT screen in the centre block. Running off a Blackpill with per-key RGB, and the switches will be sunsets....